Publicidad
Idiomas disponibles
Idiomas disponibles
®
AMPROBE
digital!
8.) Continuity testing:
Bring the probe tips into contact with the conductor, fuse, etc. that is being tested. With resistances of 0-2 k! the resistance
reading appears on the display and an acoustic signal sounds. If the reading is >2k!, the excess indicator "1" appears on the
display.
9.) FI/RCD trigger test, PE (zero conductor test):
®
The AMPROBE
digital! is equipped with an automatic load, which permits the throughput testing of FI/RCD-safety
switches without triggering. The initial task is to carry out testing between L (phase conductor) and N (zero conductor) (approx.
5s). With immediate connection, L can be tested against PE (earth/ground). The network voltage is indicated. If this is not so,
the FI/RCD safety switch is triggered (max. 30mA).
10.) Backlighting:
For operation in low-light conditions, the BL (backlight) sensor activates automatically to ensure that the screen can be read
even in total darkness.
11.) Battery replacement:
To replace the batteries, release the screw under the main casing and pull the battery compartment cover downward to remove.
Observe the correct polarity when inserting the new batteries.
Note: Batteries should not be disposed of as normal household waste. Take them to an approved collection point.
Declaration of conformity
This product is in conformity with standards of low voltage in accordance with the regulations 73/23/EEC, 89/336/EEC.
Fields of application
The tool is intended for use in applications as described in the operating instructions only.
Any other form of usage is not permitted and can lead to accidents or destruction of the device. Any misuse will result in the
expiry of all guarantee and warranty claims on the part of the operator against the manufacturer.
- 5 -
Publicidad
