Denon Lectern Active Guia Del Usuario página 6

Operation
To power Lectern Active on or off, use the power switch.
To use Lectern Active's microphone:
1. Make sure the microphone is connected properly to the XLR input above the lectern tray.
2. Speak into the microphone and adjust its position, if necessary.
To adjust the microphone volume, turn the Mic Volume knob. When the volume knob is at
the minimum position, the internal speaker will be muted.
To mute the microphone, press and hold the Mute button next to the XLR input.
To unmute the microphone, release the Mute button.
To use the podium lamp, make sure it is connected properly to the 4-pin input above the
lectern tray. The podium lamp will turn on automatically. Adjust the position of the lamp if
necessary.
Important: The 4-pin input should be used for the included podium lamp only.
To power or charge additional devices:
•
AC Power: Connect each device to an AC outlet at its base.
•
USB: Connect a device to the USB port on the rear panel.
Important: Lectern Active must be powered on to power or charge any connected devices.
To play audio:
1. Connect an audio device to one of the aux inputs—the 1/8" (3.5mm) input using a stereo
1/8" (3.5mm) cable or the RCA inputs using a stereo RCA cable.
2. Play audio on your device.
3. Turn the Aux Volume knob to adjust the output volume level. Also, adjust the input volume
level on your device.
6