Setup Scenario 3: Dj Setup; Audio Setup - M-Audio M-Track Quad Guia Del Usuario

Setup Scenario 3: DJ setup:

Headphones*
House
speakers*
Use this setup when DJing with software. Connect your computer to the rear panel USB port, and remember to select M-
Track Quad as your computer's default device for recording and playback (see the following Audio Setup section for more
information). Connect your booth monitors to the rear panel Audio Outputs 1 and 2, and connect the house speakers to Audio
Outputs 3 and 4. Connect your headphones to the front panel headphone jack. Cue up your next track in the monitors and
headphones by setting the Headphone Source Switch to 1/2, or hear the house mix by setting it to 3/4.

Audio Setup

M-Track Quad can be used with any digital audio
workstation or recording software that is compatible
with ASIO on Windows operating systems or Core
Audio on Mac OS X operating systems. To enable your
M-Track Quad to send and receive audio to and from
your computer, follow the instructions below for your
computer's operating system:
Windows:
1. Connect M-Track Quad to a power source using the included power adapter (6V, 3A, center-
positive).
2. Use the included USB cable to connect the M-Track Quad to your computer.
Go to Start Menu  Control Panel  Hardware and Sound  Sound.
3.
4. Click the Playback tab and select M-Track Quad as the default device.
5. Click the Recording tab and select M-Track Quad as the default device.
6. Click OK to close the Sound control panel.
Mac OS X:
1. Connect M-Track Quad to a power source using the included power adapter (6V, 3A, center
pin-positive).
2. Use the included USB cable to connect the M-Track Quad to your computer.
3. Click the Apple icon in the menu bar, select System Preferences, and then click Sound.
4. In both the Input and Output tabs, select M-Track Quad as your default device.
5. Close the window.
Computer*
6
DJ software controller*
Power
Booth
monitors*
Be sure your audio software program is
set up to receive audio via the M-Track
Quad. This can usually be done in your
software's Preferences, Options, or
Device Setup. Please consult your
software manual for more information.
* not included.