Installing The Bt-Hd01; Pairing The Bt-Hd01; Operation - Metra BT-HD01 Instrucciones De Instalación

Installing the BT-HD01

• Remove (3) Torx screws from the radio. (Figure A)
• Attach the BT-HD01 to the radio, then reinstall the (3) Torx screws, securing the
BT-HD01 to the radio.
• If the 4' waterproof USB cable is desired to be used, route the USB cable out
from the lower fairing to the desired location. The USB cable is designed to be
mounted with a hole drilled into the fairing, if so desired.
• Reassemble the fairing in reverse order of disassembly.
®
BT-HD01

Pairing the BT-HD01

• Turn the ignition key switch to the on position, and then turn on the radio. There
will be a new option on the radio screen titled "HDBT".
• Select this option, and then select "Pair".
• On the Bluetooth device search for "HDBT", and then pair to the BT-HD01.
Handlebar controls
• The UP and DN buttons will operate next/previous song, if applicable.
• The MODE SEL. button will cycle through the available sources.
Radio controls
• The soft buttons 1-6 will allow you to access the following features:
Pair (1), Play/Pause (2), Random (3), Next (4)
Note: After 5 seconds with no buttons being pressed, the radio will default to
the main screen.
Note: The BT-HD01 supports full text on the radio screen from most streaming
apps, pending the Bluetooth device supports AD2P.
6

Operation