Installing The Interface - Metra AX-ADGM03 Instrucciones De Instalación

From the 16-pin harness with stripped
leads (included with interface):
• Connect the White wire to the left
front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the
left front negative speaker output of
the aftermarket radio.
• Connect the Gray wire to the right
front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the
right front negative speaker output of
the aftermarket radio.
Only make the following connections
if the vehicle contains a digitally
amplified system.
• Connect the Green wire to the radio's
left rear positive
speaker output.
• Connect the Green/Black wire to the
radio's left rear negative
speaker output.
• Connect the Purple wire to the radio's
right rear positive
speaker output.
AX-ADGM03

Installing the Interface

• Connect the Purple/Black wire
to the radio's right rear negative
speaker output.
From the 22-way harness:
The Black/Yellow wire will be
discussed later on in the instructions.
The DIN plug is to be connected to the
optional XIA-LCD screen if satellite or RSE
is being retained.
From the Gray 24-way harness:
• Connect the Black wire to the ground
wire of the aftermarket radio
• Connect the Yellow wire to the
constant wire of the aftermarket radio.
• If the vehicle is amplified disconnect
the 4-pin harness located between
the 30-way and 22-way connector
and connect the supplied 4-pin to
4-pin resistor pad. If the vehicle is not
amplified connect the two 4-pins for
the 30- and 22-way together.
Only make these connections if you
do not have a digital amplifier
Amplified vehicles:
• Connect the Violet wire to the
right rear positive wire of the
aftermarket radio.
• Connect the Violet/Black wire to
the right rear negative wire of the
aftermarket radio.
• Connect the Green wire to the
left rear positive wire of the
aftermarket radio.
• Connect the Green/Black wire to
the left rear negative wire of the
aftermarket radio.
Non-amplified vehicles:
• Cut the resistors from the Green,
Green/Black, Purple, Purple/
Black right below the heat shrink.
• Connect the Violet wire to the
right rear positive wire of the
aftermarket radio.
• Connect the Violet/Black wire to
the right rear negative wire of the
aftermarket radio.
• Connect the Green wire to the
left rear positive wire of the
aftermarket radio.
2
• Connect the Green/Black wire to
the left rear negative wire of the
aftermarket radio.
From the Gray 12-Way Harness:
• Connect the Blue/Pink wire to the
aftermarket radios VSS
(if populated on factory side)
• Connect the RCA's to the AUX in on
the aftermarket radio
(if equipped) to retain RSE
and/or OE satellite.
12-Way Harness:
This harness is for the ASWC-1 (sold
separately). Please refer to the last
page in the instructions for wiring to
the pre-wired ASWC-1 harness, and to
the ASWC-1 instructions for additional
wiring and programming.
Installing the AX-ADGM03
1. With all the connections completed,
plug the 24-, 22-, and 12-pin
harnesses into the AX-ADGM03.
2. Plug the 24- and 12 pin GM harness
into the vehicle side harness, and