Información De Cumplimiento; Fcc Compliance - SMA EDMM-10 Instrucciones De Funcionamiento

Ocultar thumbs Ver también para EDMM-10:
Tabla de contenido

Publicidad

15 Información de cumplimiento
15 Información de cumplimiento

FCC Compliance

This device complies with Part 15 of the FCC Rules and with Industry Canada licence-exempt RSS
standard(s).
Operation is subject to the following two conditions:
1. this device may not cause harmful interference, and
2. this device must accept any interference received, including interference that may cause
undesired operation.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio
exempts de licence.
L'exploitation est autorisée aux deux conditions suivantes :
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le fonctionnement.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications made to this equipment not expressly approved by SMA Solar
Technology AG may void the FCC authorization to operate this equipment.
RF Exposure Statement
Radiofrequency Radiation Exposure Information:
This equipment complies with FCC radiation limits set forth for an uncontrolled environment. This
equipment should be installed and operated with minimum distance of 20 cm (8 in) between the
radiator and your body.
IC Compliance
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du Canada.
60
EDMM-10-BE-es-21
SMA Solar Technology AG
Instrucciones de funcionamiento

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Edmm-us-10Data manager m

Tabla de contenido