Before Installing; Technical Data - CAME RKLT-WR Manual De Usuario

Legend of symbols
EN

Parts to read carefully.
⚠
Parts about safety.
Beep: sound warning made by the
control unit to notify that programming
1
is completed.
Maximum time to execute the procedure.
1'

Before installing

ATTENTION: IMPORTANT SAFETY INSTRUCTION
It is important to follow these instructions for the safety
of people.
Keep these instructions.
⚠
Only skilled, qualified staff must install this
product.
• This product is only meant to be used for its intended
purpose. Came S.p.A. is not liable for any damage caused
by improper, wrongful or unreasonable use. • Keep children
from playing around the fi xed command-devices. Keep the
portable command-devices away from children. • Set up
a dual-pole cut-off switch with minimum contact openings
of 3 mm, and section-off the power supply.
⚠
It is strictly forbidden to: perforate, sink in
water, hammer, deform, fi t nails or screws into,
dismantle or tamper with the device.
Intended use
Radio repeater for extending the range, in closed settings,
of compatible and enabled transmitters.
Compatible with all KLT-series transmitters and timers.

Any installation and/or use other than that specifi ed
in this manual is forbidden.

TECHNICAL DATA

RKLT-WR
Power draw 0.54 W
Current draw 30mA
Operating temperature 0°C / +55°C
Power supply 230 V AC ± 5% 50 Hz
Reception frequency 433.92 M Hz
Protection rating IP X0
CABLE TYPES AND SECTIONS
Control panel power-
Connection
supply
Cable type EN 50267-2-1
Cable length 1 < 10 m 3G x 0.75 mm
Cable length 10 < 20 m 3G x 1 mm
Cable length 20 < 30 m 3G x 1.5 mm
Installing
⚠
The installation must be done by qualified
expert technicians and in full compliance with
applicable laws and regulations.
⚠
Only to be fi tted into junction boxes or similar
devices.
⚠
Perform all connections after cutting off the
mains power supply.
Install equidistantly between the transmitter and the receiver
to command.

If two repeaters are fi tted to the same system, bridge
the jumper on the second repeater.
The control unit is subject to disturbances from external
elements, like masses, metal covers and electromagnetic
fields, high-frequency radio transmissions, that could
hamper the proper functioning of the control unit; so, please
use plastic containers, and set the antenna so that it is far
from the power-supply cables.
• Connect the wires to the terminals, by following the
scheme in Fig.
"Electrical connections" chapter.
⚠
The container must not be perforated for any
reason.
2
2
2
and the instructions stated in the
119T70571 - ver. 1 1 - 07/2016 119T70571