CAME RKLT-WR Manual De Usuario página 9

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
ANTENNA
For operating normally, the control unit features a 17 cm
insulated cable-antenna.
Do not cut or change the antenna cable in any
way.
PRELIMINARY CHECKS
The control unit must be fi tted in fl ush mounting junction
boxes and be impact protected.
Set up suitable conduits and tubes to safely run
the electrical cables through and to protect them
from mechanical damage.
Electrical connections
You must not deviate from the required electrical
connections.
A wrong connection may cause serious damage
to the control unit.
Network power supply
brown (phase)
blue (neutral)
yellow green (earthing safety)
Getting started
All memorization sequences are on a timer.
When powering up: the control unit emits a sound.
The control unit only repeats signals sent from enabled
transmitters.
The repeated command is sent after two seconds of
reception.
With the jumper bridged, the waiting time doubles: this
is to prevent overlapping of incoming signals from the
two repeaters. The blue LED lights up whenever the
radio transmits.
ENABLING TX
1. Press the programming button on the cover;
2. the control unit emits a sound signal;
3. within 20 seconds, press any key on the Tx that you
want enable;
4. the control unit emits a sound signal.
You can enable at most 20 Tx (including the weather units
and/or timers).
If you try to add a 21st tx, the control unit will beep
three times consecutively to signal that the memory
is full.
DELETING ALL THE MEMORIZED TXS
To delete all the memorized txs, keep the programming
button, on the control unit, pressed until the control unit
emits an acoustic signal.
Dismantling and disposal
Before disposing, it is always advisable to check with
the specifi c laws that apply in your area. The packa-
ging materials (cardboard, plastic, and so on) should be
disposed of as solid household waste, and simply se-
parated from other waste for recycling. Whereas other
components (electronic boards, batteries, transmitters,
and so on) may contain hazardous pollutants. These
must therefore be disposed of by authorized, certifi ed
professional services.
DO NOT DISPOSE OF IN NATURE!
The data and information in this manual may be changed at any
time and without notice.
CE Declaration of incorporation
Came S.p.A. declares that this device conforms to the
essential, pertinent requirements provided by directive
2014/53/EU.
Contact Came S.p.A. to receive an original copy.
Visit came.com for any extra information or for troubleshooting.
119T70571 - ver. 1 1 - 07/2016
119T70571

Publicidad

Tabla de contenido
loading

Tabla de contenido