Esp Function - LG Multi Manual Del Propietário

ESP Function

E.S.P function is setting the volume of each fan speed. It is for the convenience of installation. It is recommended
that you should not use this function while using the remote controller.
PQRCUCS0C
Defrost Preheat
TEMP
FAN
MODE
SPEED
TEMP
Out door
Room Temp
Total on
Central Run
Necessary functions before using
1
Press the mode button and the temperature increasing
button(L) same time for three seconds.
2
Set the volume of each fan speed(Low, Medium, Hi)
by using the temperature control button. Press the fan
speed button to select the fan speed.
The value of E.S.P can be adjusted from 1 to 255.
3
If you press the On/Off button while setting the ESP
function, it will be canceled. (The picture on the left
side is the example of setting the Hi wind to ESP 10.)
4
Press the mode button and the temperature increasing
button (L) same time for three seconds. Then the ESP
setting will be activated after the temperature display
flashes three times.
EX)
Lo
200
Setting the Low wind to 210
❈ The E.S.P value is set at the proper value at the factory. So
it is highly recommended that you should not change the
E.S.P value at your discretion.
Med
100
Setting the Medium wind to 175
Owner's Manual 9