Door/Wi N Dow Sensor - Logan L-SA01 Manual De Usuario

in grey color.
8. When those sensors such as door/window sensor, PIR detector are i n low battery, the APP will push low
battery alert message every two hours. (Thi s functi o n can be turn off), also i n sensor management i n terface
there wi l l be low battery icon li s ted.
9. Door sensor closed/open status can be checked and i f door had not been closed properly when host
armed, APP wi l l push alert message, also i n sensor management i n terface there wi l l be door open/closed
status i c on listed.
4.3.13 Phone Call Alarm Handli n g
1. If choose GSM network (with GSM SIM card i n sert),the system wi l l push alarm i n formati o n to Logan Alarm APP ,
and i t wi l l also send SMS and make phone call to preset mobi l e numbers. If don't choose GSM network, it wi l l
neither send SMS text message nor make calls when alarmi n g. If choose "smart mode", alarm host wi l l send
SMS and make phone call to preset phone numbers i n the si t uati o n of Wi-Fi network breakdown.
2. When using GSM network, alarm host wi l l send SMS fi r stly and then make phone call to preset mobile
numbers. If someone answers it, the calli n g wi l l stop, then heari n g the pre-record and alarm voi c e message, get
into li s tening status. At this moment, press "1" on mobi l e keypad, host wi l l be i n armed status, press"2", get i n to
di s armed status, press"3" to start siren, press "4" to close si r en prompt. If the calli n g i s busy or no answer, i t will
auto di a l to next mobi l e phone number unti l someone answers i t . It wi l l call 3 ti m es i n cycle, i f sti l l no answer, it
wi l l stop calli n g finally.
5. Accessories
5.1 PIR Motion Sensor
strip.
2. Paste the two parts on
adhesive tape.
3. When magnets move
distance, it wi l l be triggered
Installati o n:
1. Open the shell, remove the i n sulation strip.
2. Mounti n g i t on the wall wi t h hei g ht at 20 meters.
3. To prevent false alarm, avoi d faci n g vents, ai r conditi o n, etc. places.

5.2 Door/Wi n dow Sensor

Installation:
1. Open the shell, remove the i n sulati o n
wi n dow/door wi t h a double sided,
away from transmi t ter for 2cm
to alarm.