Fluidmaster K-400H-021 Guía De Inicio Rápida página 5

STEP 4:
INSTALL TANK-TO-BOWL GASKET
A: IDENTIFY YOUR GASKET
All Other
(Below)
ALL OTHER TOILETS:
A: INSTALL LOCKNUT
Holding flush valve in place, place friction washer onto
bottom of flush valve then hand-tighten locknut to secure.
red wrench to go ½ turn beyond hand-tight.
Use
Do not overtighten.
B:
Apply red tank-to-bowl gasket to
bottom of flush valve locknut, fully
covering locknut. Proceed to Step 5.
NOTE:
For Gerber ® toilets, see p.9.
For Kohler ® toilets, see p.10.
8
Gerber Kohler
® ®
(p.9) (p.10)
Red Wrench
STEP 4:
GASKET FOR GERBER
GERBER TOILETS:
®
A:
Tear the three perforated tabs off
the black gasket.
B: INSTALL LOCKNUT
Place the black gasket (a) onto the
bottom of the valve, followed by the
friction washer (b) and locknut (c).
C:
Hand-tighten the locknut to secure the flush valve. Use the
red wrench to tighten the locknut 1/2 turn beyond hand-
tight. Do not overtighten.
D:
Place red gasket onto bottom of the
valve, covering the locknut and nesting
inside black gasket.
*
Proceed to Step 5.
TOILETS
®
a
b
c
Red Wrench
9