Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 8: INSTALL LEVER & FLAPPER CHAIN
If the removed tank lever is bent, proceed to Step A1 below. If the
lever is not bent then proceed to Step A2 below.
A1: FOR SIDE OR ANGLE MOUNT:
BEND NEW LEVER ARM
To bend lever, start bend 2" after 90
degree elbow until bend matches the
old lever. Do not bend arm quickly or
back and forth repeatedly.
A2: FOR FRONT MOUNT:
MEASURE LEVER ARM
Measure length of old lever
arm next to new lever arm. If
necessary, trim new arm (with
Mini Hack Saw
a hacksaw) at the cut line.
(Optional)
B:
INSTALL LEVER
Slide lever through tank hole. Slip
locknut over lever arm (flat side of nut
facing handle). Hand-tighten locknut
clockwise (reverse thread) *Do not
overtighten.
C:
CONNECT FLAPPER CHAIN
Attach clip to the tank lever directly
above the flapper. Leave roughly ½"
of slack (small 'J' shape) in the chain.
16
STEP 9: FINISHING STEPS
A: ATTACH WATER SUPPLY
CONNECTOR TO FILL VALVE
Twist to the right (counterclockwise)
*Hand-tighten only. Do not overtighten.
ONLY BEND
LEVER HERE
B:
TURN ON WATER
Check for leaks.
C: WATER LEVEL
After the tank stops filling, water level should fill the tank to
roughly ½" below top of overflow pipe to ensure a proper flush.
(Does not need to be exact.)
*
Overtightening may damage fill valve or coupling nut, potentially causing flooding.
Make sure the float cup does not touch the tank walls or tank lever and flush valve.
**
The top of the overflow pipe must be a minimum of 1" below tank lever hole.
Lever Hole
RIGHT
TURN
COUNTER-
CLOCKWISE
Top of
Overflow Tube
1/2"
Water Level
Overflow Pipe
17
Publicidad
Tabla de contenido
