Powering On And Off - Zagg Slim Book Manual Del Usuario

INSERTING/REMOVING YOUR IPAD PRO™
Because the power and volume control buttons on your iPad Pro sit higher
than on other devices, you need to take extra care when inserting it into the
Slim Book cover. To insert your iPad Pro into the Slim Book:
1. Hold your iPad Pro at an angle so that its Power and
volume control buttons are angled toward the cover,
and aligned with their respective holes.
2. Set this end of your iPad Pro into the case, then slowly
lower the rest of your iPad into the case and press it in.
Check all corners to make sure they have seated properly.
When your iPad is secure in the case, you can connect it to
the keyboard by placing it in the magnetic trough. Powerful
magnets will secure it in place, but also allow you to remove
your iPad any time it benefits you.
To easily remove your iPad from the case, separate the case
from the keyboard, and then gently roll the rubber overmold
away from the edges while pressing the tablet from behind.
Grasp your tablet's exposed side and lift/pull away from the
Slim Book.

POWERING ON AND OFF

To turn your Slim Book on, press the
the battery key will illuminate briefly while the 8keyboard powers up. To
turn your Slim Book off, press and hold the
seconds. A red LED will flash, indicating your Slim Book has turned off.
DISCONNECTING YOUR KEYBOARD
Your Slim Book features a case that protects your iPad even when it's not
connected to your keyboard. When you'd like to use the case without the
keyboard, there are three ways you can disconnect your keyboard.
1
Power button. A green LED on
Power button for three