Getting Started; Battery Installation - Williams Sound Pocketalker PKT 2.0 Manual Del Usuario

Getting Started

1. Open the battery cover: Using your thumb, apply firm pressure on the
ridges of the cover and slide it down and away from the Pocketalker.
2. Switch the Battery Type Switch to the position for the battery type
that will be used (NiMH or Alkaline).

Battery Installation

*NOTE: If using rechargeable NiMH AAA batteries, the battery switch
MUST be switched to the NiMH position to allow charging!
3. Press 2 AAA batteries into place in the battery compartment,
being careful to observe correct placement of (+) and (–)
terminals.
4. Your Pocketalker system is supplied with the headphone
and earphone for best performance. Williams Sound offers
additional options - visit www.williamssound.com.
WARNING!
6
Battery
Type*
Switch
NiMH
Alkaline
AAA
Batteries
NiMH* or
Alkaline*
PRESS HERE
WHILE SLIDING
Battery
Cover
Do not attempt to charge Alkaline batteries!
SLIDE