Cleaning And Disinfection; Technical Data; Replacement Part; Warranty - Riester HL 150 Manual Del Usuario

7.

Cleaning and disinfection

Caution: Pull out the mains plug before cleaning!
All external surfaces of the instrument (casing, front plate, rear panel) are non-reactive to all common cleaning and disinfecting agents,
so that these may be used without restriction. A soft cloth or absorbent paper should be used to apply cleaning or disinfecting liquids, in
order to avoid scratching the surface and to dose and distribute the liquid better.
Do not simply pour and then distribute the cleaning and disinfecting agents on the casing. Especially liquids which are inflammable, such
as alcohol, should be measured out using a cloth. Do not allow any liquid to run inside the instrument. After cleaning with an inflammable
liquid, allow the instrument to dry for at least 1 hour before it is switched on again. Otherwise there is a danger of an explosive mixture of
air and cleaning agent igniting when switching the instrument on.
8.

Technical data

Mains voltage
Lamp
Power consumption
Mains fuses
Protective class
Certification
Dimensions
Weight

9. Replacement part

Lamp 150W Halogen
Replacement fuse
Adapter type Storz, for cold-light cable projector side
Adapter type Wolf, for cold-light cable projector side
Adapter type Olympus New, for cold-light cable projector side
Adapter type ACM British, for cold-light cable projector side
Adapter type Pentax, for cold-light cable projector side
Adapter type Fuji, for cold-light cable projector side
Tripod with support plate
Replacement cable with plug Mains cable
Replacement cable with plug Mains cable US
Replacement cable with plug Mains cable UK
This product has been manufactured under the strictest quality standards and has undergone a thorough final quality check before lea-
ving our factory.
We are therefore pleased to be able to provide a warranty of
on all defects, which can verifiably be shown to be due to material or manufacturing faults. A warranty claim does not apply in the case of
improper handling.
All defective parts of the product will be replaced or repaired free of charge within the warranty period. This does not apply to wearing
parts.
A warranty claim can only be granted if this Warranty Card has been completed and stamped by the dealer and is enclosed with the pro-
duct.
Please remember that all warranty claims have to be made during the warrantyperiod.
We will, of course, be pleased to carry out checks or repairs after expiry of the warranty period at a charge. You are also welcome to
request a provisional cost estimate from us free of charge.
In case of a warranty claim or repair, please return the RIESTER product with the completed Warranty Card to the following address:
Rudolf Riester GmbH & Co. KG
Dept. Repairs RR
Bruckstr. 31
72417 Jungingen
Germany
Serial number or batch number
Date
Stamp and signature of the specialist dealer
6
230V AC ± 10 %
115V AC ± 10 %
Halogen reflector lamp 15V, 150W (average service life 500 hours)
160W
2 miniature, slow-to-burn fuses, 5 x 20 mm
BF
CE
W 245 x H 120 x D 200 mm
3.5 kg.

Warranty

2 years from the date of purchase
Order No.
12132
12138
12126
12127
12128
12129
12130
12131
12120
12135
12136
12137