To Operate The Product; To Adjust The Harness; To Stop The Product - Husqvarna 150BT Mark II Manual De Usuario

1. Put the product in a cool area away from open
sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again for 10-15
seconds.
4. Obey the procedure to start a cold engine. Refer to
To start a cold engine on page 8 .

To operate the product

• Operate the product at usual work hours. Obey local
regulations.
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note:
Husqvarna recommends that you use the
full blower nozzle extension.
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.

To stop the product

CAUTION:
full speed.
1. Push the stop switch.
10
Do not stop the product at
0
Note:
When the product stops, you can hear a
knock sound. This is typical and is not an indication
of a defective product.

To adjust the harness

1. Put on the harness of the product.
2. Put the waist belt around your waist and connect the
belt buckle for the waist strap.
3. Tighten the waist belt strap.
4. Connect the belt buckle for the chest strap.
5. Adjust the position of the chest strap.
1456 - 002 - 06.05.2021