To Start A Cold Engine; To Fill The Fuel Tank - Husqvarna 150BT Mark II Manual De Usuario

quantity of oil carefully and make sure that
you get the correct mixture.
1. Fill half the quantity of gasoline in a clean container
for fuel.
2. Add the full quantity of oil.
3. Shake the fuel mixture.
4. Add the remaining quantity of gasoline to the
container.
5. Carefully shake the fuel mixture.
CAUTION:
than 1 month at a time.

To fill the fuel tank

WARNING:
follows for your safety.
1. Stop the engine and let the engine become cool.
2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8
Do not mix fuel for more
Obey the procedure that
Make sure that there is
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to

To start a cold engine

WARNING:
the engine is started, even when it idles. Do
not let anyone stand close to the blower or
the blower tube.
1. If the engine is cold, put the choke control (A) to the
closed choke position. Refer to
product on page 3 .
2. Push the air purge bulb (B) again and again for a
minimum of 10 times and fuel starts to fill the air
purge bulb. It is not necessary to fill the air purge
bulb fully.
3. Put the throttle control in the fast idle position. Align
the guide marks on the throttle control lever and the
control handle.
4. Put the product on a flat surface on the ground.
Air is released as soon as
Symbols on the
B
A
1456 - 002 - 06.05.2021