To Operate The Product; To Start A Warm Engine; To Use The Throttle Trigger; To Stop The Product - Husqvarna 150BT Manual De Usuario

Note:
repeat the starting instructions from step
1.
10. Let the engine run for 30 seconds.
11. Put the throttle control at idle speed.
12. Push the throttle trigger to adjust the blower speed.
To use the throttle trigger on page 10 .
Refer to

To start a warm engine

• Use the same starting procedure as
the choke control in the closed choke position.

To use the throttle trigger

• To increase the blower speed during operation, push
the throttle trigger until you get the correct speed.
• To decrease the blower speed during operation,
release the throttle trigger until you get the correct
speed.
To start the engine when the fuel is too
hot
If the product does not start, the fuel can be too hot.
10
If the engine does not start,
# but do not put
Note:
Always use new fuel and decrease the
operation time during warm weather.
1. Put the product in a cool area away from open
sunlight.
2. Let the product cool down for 20 minutes at
minimum.
3. Press the air purge bulb again and again for 10-15
seconds.
4. Obey the procedure to start a cold engine. Refer to
# .

To operate the product

• Operate the product at usual work hours. Obey local
regulations.
• Decrease the pieces of equipment and select the
correct speed for your task. Use the throttle at lowest
position possible to prevent more noise and dust
than necessary.
• Keep the blower nozzle near the ground.
Note:
Husqvarna recommends that you use the
full blower nozzle extension.
• Make a note of the wind direction and operate the
product in the direction of the wind.
• Use applicable garden tools to release material from
the ground.
• In areas with dust, use spray equipment to wet the
area. This decreases the operation time.
• After operation, keep the product in storage
vertically.

To stop the product

CAUTION:
full speed.
Do not stop the product at
1456 - 002 - 06.05.2021