To Start A Cold Engine - Husqvarna 150BT Manual De Usuario

Ocultar thumbs Ver también para 150BT:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

2. Clean the area around the fuel tank cap.
3. Shake the container and make sure that the fuel is
fully mixed.
4. Remove the fuel tank cap slowly to release the
pressure.
5. Fill the fuel tank.
CAUTION:
not too much fuel in the fuel tank. The
fuel expands when it becomes hot.
6. Tighten the fuel tank cap carefully.
7. Clean fuel spillage on and around the product.
8. Move the product 3 m/10 ft or more away from the
refueling area and fuel source before you start the
engine.
Note:
To see where the fuel tank is on your product,
Product overview on page 2 .
refer to

To start a cold engine

WARNING:
the engine is started, even when it idles. Do
not let anyone stand close to the blower or
the blower tube.
1. If the engine is cold, put the choke control (A) to the
closed choke position. Refer to
product on page 3 .
2. Push the air purge bulb (B) again and again for a
minimum of 10 times and fuel starts to fill the air
purge bulb. It is not necessary to fill the air purge
bulb fully.
1456 - 002 - 06.05.2021
Make sure that there is
Air is released as soon as
Symbols on the
B
A
3. Put the throttle control in the fast idle position. Align
the guide marks on the throttle control lever and the
control handle.
4. Put the product on a flat surface on the ground.
5. Hold the product with the left hand and put your foot
on the foot plate.
6. Pull the starter rope handle slowly with the right hand
until resistance occurs.
Note:
Do not pull the starter rope handle to full
extension and do not let go of the starter rope
handle.
7. Pull the starter rope handle quickly with the right
hand until the engine starts or attempts to start,
maximum 6 times. If the engine starts, move the
choke lever gradually to the open position and
continue to step 11. If the engine does not start,
continue to step 9.
8. When the engine attempts to start, move the choke
lever gradually to the open position.
9. Pull the starter rope handle quickly with the right
hand until the engine starts, maximum 6 times.
9

Publicidad

Tabla de contenido
loading

Tabla de contenido