Installation Instructions - Walimex Pro Softbox Manual De Instrucciones

4. Installation instructions

Step I
Put all of the rods through the loops of the
softbox / striplight. Open the straps on the
end of the softbox umbrella.* This will make it
easier to tension the rods later.
Step II
Put the end-piece with the long sleeve into
the fixing hole of the softbox / striplight.
Step III
Place the speed ring in the centre of the
softbox. The speed ring is used with the
slits at the top (towards the centre of the
softbox) to set it up. First of all, slide the
rods into the openings of the speed ring
that don't have a slit. Then, slide the last
rod with the fastening unit into one of the
openings with a slit (perpendicularly). Push
the rod down very firmly. Then push the
loose fastening unit on the rod strongly
and firmly into the opening of the speed
ring. The wheel does not screw in.
14
II
III
III