Remote Punch Bass - Rockford Fosgate PUNCH RFT3061A Instalación Y Operación

2. Connect the RCA cable inputs into their perspective plugs on the amplified subwoofer.
High Level (H.L.) Input connection
1. Using the cord profided, splice directly into the source unit's speaker outputs. Do not break
connection with the source unit and speakers. Be sure to maintain proper speaker polarity.
DO NOT chassis ground any of the speaker leads as unstable operation may result.
NOTE: REM connection is not required for this method. When power is supplied to the
speaker wires from the source, the amplified subwoofer will automatically turn on.

REMOTE PUNCH BASS

Mounting and installation
1. Find a location, either under the dash
or near the center console, that gives
easy access to the remote.
2. Using the screws supplied, install the
mounting clip with the tabs towards
the back.
3. Route the cable for the remote and
connect to both the remote and
amplifed subwoofer.
4. Slip the remote onto the mounting
clip until it snaps into place.
5. Install the decal and knob onto the remote.
Mounting
Clip
Knob
Decal
I
NSTALLATION
7