Removing The Refrigerator Doors; Tools You'll Need - Samsung RH25H5611 Manual De Usuario

How to install the handles
Using a Philips head screwdriver, attach fixer
screws to the screw holes on each door.
If your refrigerator already has the fixer screws
installed, skip this step.
Orient each handle so that the end with the sticker
attached is at the top and the holes for the screws
are facing the screw holes on the refrigerator door.
Place a handle over the fixer screws on one door,
and then slide the handle down firmly.
Repeat with the second handle on the other door.
For Models with a lever attached to the right
handle, push the lever button on the handle in,
hold it in place, and then slide the bottom of the
handle down over the fixer screw.
L
( 2 )
Using the include hex wrench, tighten the set
screw on the top inside section of each handle.
Use the longer part of the hex wrench to begin
tightening, and then the shorter part to tighten the
screw fully, as shown in the diagram below.
DA68-02981J-00.indb 11
( 1 )
( 3 )
Fix the handles to the doors
by sliding them down firmly.
English - 11
( 4 )
L
REMOVING THE REFRIGERATOR
DOORS
If your entrance won't allow the refrigerator to pass
through it easily, you can remove the refrigerator
doors.
To remove the doors, follow the steps below.
If you do not need to remove the doors, go to
"Leveling the Refrigerator" on page 14.

Tools You'll Need

Philips Flat-blade
Screwdriver Screwdriver
1. Remove the Front Leg Cover
Open both the freezer and refrigerator doors.
Unscrew the three screws holding the front leg
cover in place by turning them counter-clockwise.
When the screws are loose, remove the front leg
cover.
CAUTION
When disassembling, make sure the unit is turned
off.
( 5 )
S
10 mm Socket
Wrench
Front leg cover
Screw
14. 11. 6. 2:05