Setting Up The Refrigerator; Removing The Refrigerator Doors; Tools You Will Need - Samsung RF265AB Manual Del Usuario

Ocultar thumbs Ver también para RF265AB:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

SETTING UP THE REFRIGERATOR

Now that you have your new Refrigerator installed and in place, you are ready to set up and enjoy the features and
functions of the appliance.
By completing the following steps, your Refrigerator should be fully operational.
1. Place the Refrigerator in an appropriate location
with reasonable clearance between the wall and
the Refrigerator. Refer to installation instructions in
this manual.
2. Once the Refrigerator is plugged in, make sure the
interior light comes on when you open the doors.
3. Set the Temperature control to the coldest
temperature and wait for an hour. The Freezer will
get slightly chilled and the motor will run smoothly.
4. After powering the Refrigerator, it will take a few
hours to reach the appropriate temperature. You
can store food and drinks in the Refrigerator once
the temperature is sufficiently cool.
Check the accessory list below.

REMOVING THE REFRIGERATOR DOORS

If your entrance won't allow the Refrigerator to pass easily
through it, you can remove the doors.
Disassemble the Refrigerator doors
1. With the door closed, remove the top table(
using a Philips screwdriver, and then disconnect the
wires(
). Remove hinge screws(
2
screw(
)
4
2. Lift the door straight up to remove.
3. With a Philips head screwdriver, remove the two
screws(
) attached to the lower left and right
10
door hinges.
With an Allen Wrench(3/16"), remove the two hex
head bolts(
) attached to the lower left and right
11
door hinges.
Remove the lower left and right door hinges(
Water filter
(DA29-00003B)

Tools you will need

Philips screwdriver
Flat-blade screwdriver
)
1
) and ground
3
).
12
Hex wrench
Compression
Compression
(DA80-00002C)
fitting
(DA62-00305A)
(DA74-00070B)
Fastener
Washer
(DA60-00143B)
(DA80-00002C)
10mm Socket Wrench
Allen wrench(3/16")
Pliers
3
4
12
10
11
Setting Up _9
nut
1
2

Publicidad

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Rf266ab

Tabla de contenido