Cedar Ridge CRHQD250TA Manual Del Propietário página 21

Use a vacuum cleaner, pressurized air, or a
small, soft bristled brush to clean.
A yellow tip on the pilot flame indicates dust
and dirt in the pilot assembly. There is a small
pilot air inlet hole about 2" from where the
pilot flame comes out of the pilot assembly
(see Figure 24). With the unit off, lightly blow
air through the air inlet hole. You may blow
through a drinking straw if compressed air is
not available.
CABINET
Air Passageways
Use a vacuum cleaner or pressurized air to
clean.
Exterior
• Use a soft cloth dampened with a mild soap
and water mixture.
• Wipe the cabinet to remove dust.
200124-01C
CARE AND MAINTENANCE
ODS/PILOT
www.usaprocom.com
Ignitor
Natural Gas
Electrode
Burner
Pilot Air
Inlet Hole
Figure 24 - Pilot Inlet Air Hole
LOGS
• If you remove logs for cleaning, refer to
Installing Logs, page 16, to properly replace
logs.
• Replace log(s) if broken or chipped (dime-
size or larger).
Thermocouple
Propane/LP
Gas Burner
Pilot Air Inlet Hole
21