Control Panel - Aircare 7D6100 Guía De Uso Y Cuidado

DIGITAL DISPLAY
PRESS TO
INCREASE
HUMIDITY
HUMIDITY CONTROL
3) The hygrometer on the cord reads the current room humidity and displays
the percentage on LCD panel.
4) To set the desired humidity, press the HUMIDITY button. Each successive
push increases the humidity in 5% increments. The range is 25% to 65%.
5) At 65% the humidifier will run constantly with or without water.
NOTE: If excessive condensation occurs, reduce fan to a lower speed setting.
CAUTION: Disconnect power before filling, cleaning or servicing unit.
Keep grille dry at all times.
CHECK FILTER
The ability of any humidifier to efficiently supply humidity output relies heavily on the
condition of the filter. As the filter loads with impurities it gradually loses its wicking
capability. When this happens, moisture output is reduced and the humidifier has to
work longer to satisfy the selected setting.
This humidifier has a check filter reminder timed to appear after
720 hours of operation. When the Check Filter (CF) message is
displayed, disconnect the power cord and check the condition of
the filter. If a build-up of deposits or severe discoloration is
evident replace the filter to restore maximum efficiency.
The CF function is reset after plugging the unit back in.
CONTROL LOCK FEATURE
To avoid unwanted tampering with the humidifier settings the
controls can be locked.
ACTIVATION PROCEDURE
Control Lock
After the humidifier functions have been set up, hold the Speed
Display
and Humidity buttons down for 5 seconds. The display will show
"CL" for 2 seconds; release the power button and the control will resume the
display of the room humidity. The humidifier will continue to function with the
locked in settings. If buttons are operated while "CL" is active, the "CL" is
displayed and settings are unaffected.
DEACTIVATION PROCEDURE
To deactivate the "CL" function simply press and hold both buttons for 5
seconds. "CL" will flash at the rate of 1 second on and 1 second off for a period
of 2 seconds and then resume the display of room humidity.

CONTROL PANEL

TO TURN ON/OFF
For initial operation, plug the unit
in (the display will show - -). Press
the speed button and hold for 5
seconds to turn the unit on or off.
FAN SPEED
The 7D6100 has a four speed
digital control panel.
1) Press the SPEED button to
PRESS AND HOLD
TO TURN UNIT ON
2) The speeds: High (F4) - Low (F1)
PUSH TO ADJUST
FAN SPEED
6
adjust the fan speeds
display on the digital panel.
Check Filter
Function Display