Adapting To Different Types Of Gas - Fulgor Milano FOBQ 1000 G X Instrucciones Para La Instalación Y El Uso

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Adapting to different types of gas

If the appliance is configured for a different type of gas than
that available, you have to replace the injectors with ones
corresponding to the type of gas to be used (see tables on
the preceding pages). The replacement will be made using
an adequate 7 mm key after having lowered the burners as
in the following images. After replacing the injector, regulate
the air to 1mm for natural gas and to the maximum if LPG.
To adjust the minimum, after lighting the burner, remove the
knob and the gasket below and rotate the screw of the tap
(B - see page 12), which should be totally closed for
LPG and opened about 3/4 turn for natural gas, keeping
in mind that a flame lower than 3 mm may not even be
"perceived" by the thermocouple of the tap. After regulating
the minimums, replace the gaskets and knobs.
1 - Unscrew the fixing screws of the burner.
FRONT
2 - Lower the burner and replace the injector.
BACK
BACK
FRONT
EN
11

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Fobq 1000 g mbkFobq ll 1000 xFobq ll 1000 mbk

Tabla de contenido