Gas Connection; Rigid And Semi-Rigid Metal And Rubber Hose Connection - Fulgor Milano FOBQ 1000 G X Instrucciones Para La Instalación Y El Uso

EN
12
NOTES
• The appliance MUST only be installed and serviced by
qualified and authorized personnel.
• The product is exclusively intended for outdoor use.
• The product must be installed according to the instructions,
which require ventilation openings to allow the grill to work
properly. The lack of adequate ventilation to supply air to
the appliance can lead to poor operation of the burners or
excessive heat build-up in the installation compartment.
• The unit's ventilation openings must not be covered during
installation.

Gas connection

Connect the appliance to the cylinder or system according to
the requirements of current law, making sure that the appliance
is configured for the type of gas available. If not, see: "Adapting
to different types of gas". Also check that the feed pressure falls
within the values shown in the table: "Gas specifications".
Rigid and semi-rigid metal and rubber hose
connection
Make the hook-up with metal fittings and pipes (even flexible
hoses) so as not to stress the components inside the appliance.
A rubber hose connection complies with current law only if
the hose can be inspected along its entire length and easily
replaced near the expiration indicated on the hose.
NOTE: - After installation, use soapy water to check the perfect
seal of the entire connection system. DO NOT USE AN OPEN
FLAME TO CHECK THE GAS SEAL.
X