Connection Of The Lpg Cylinder - Fulgor Milano FOBQ 1000 G X Instrucciones Para La Instalación Y El Uso

WARNING
Make sure the LPG cylinder valve or regulator is closed.
Connect the LPG cylinder.
Some regulators are connected by pushing ON and are
disconnected by pulling OFF, while other types of regulators
have a nut with left hand thread for connecting to the
cylinder valve. Follow the illustrations in the instructions for
the specific connection of the regulator.
a) Screw the regulator to the cylinder by turning it counter-
clockwise (1). Install the regulator so that the vent hole
(2) is facing downward.
b) Screw the regulator to the cylinder by turning it counter-
clockwise (3).
c) Make sure that the regulator lever (5) is in the lowered or
off position.
Press the regulator on the cylinder valve until you hear a
click indicating that it is in position (6).
d) Make sure that the regulator lever is in the OFF position.
Lift the bezel of the regulator (7). Press the regulator onto
the cylinder valve and hold it pressed. Lower the bezel
(8). If the regulator does not lock, repeat the procedure.

8 - Connection of the LPG cylinder

EN
23