Cequent REESE Towpower 88001 Guia De Inicio Rapido página 11

DRILLED HOLE
BUMPER
BRACKET
USE THIS HOLE
FOR CENTER
SECTION ASSEMBLY
USE THIS HOLE
AS A GUIDE TO
DRILL FOR
TOYOTA PICK-UPS
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
90-93 MAZDA PICK-UP
1. Raise the brackets up to the frame with the bracket as far forward toward the front of the truck as possible. Do
not let the bracket rest upon the weld in the frame. Clamp in place.
2. Drill a 1/2" hole into the frame using hole 3 as a guide. Thread a 1/2" carriage bolt onto the pull wire and place a
bolt plate over the bolt. Push the free end of the pull wire into the open end of the frame and bring it out through
hole 3. Pull the bolt down through hole 3. Unscrew the wire.
3. Make sure hitch is level. Drill a 1/2" hole through the bumper bracket using hole 6 as a guide.
4. Install center section per SIDE BRACKET LOCATION 1. (See page 2.)
5. Insert a 12mm bolt from the outside, into hole. Install 1/2" flat washers, lock washers, and nuts on all bolts.
84-95 TOYOTA PICK-UP
1. Place the brackets up to the frame with hole 3 under the forward hole in the frame. Place a 1/2" thick spacer
between the frame and hole 3. Insert a 1/2" carriage bolt with bolt plate down through the hole in frame and into
hole 3. Install 1/2" flat washers, lock washers, and nuts on the bolts. Snug up the nuts.
2. Make sure the hitch is level. Drill through hole 5 and into the bumper bracket.
3. Install center section per SIDE BRACKET LOCATION 1. (See page 2.)
4. Insert a 12mm bolt through the outside of the bracket and into hole 5. Install 1/2" flat washers, lock washers,
and nuts on the bolts.
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE
INSTALLATION E
1/2 X 2" CARRIAGE BOLT
1/4" BOLT PLATE
USE 1/2" THICK SPACER FOR TOYOTA PICK-UPS
1/2" FLAT WASHER
1/2" LOCK WASHER
1/2" HEX NUT
12mm X 1.75 X 40mm
HEX BOLT
USE THIS HOLE
AS A GUIDE TO
DRILL FOR
MAZDA PICK-UPS
TOOLS REQUIRED
3/4" SOCKET
1/2" DRILL
TORQUE WRENCH
SAFETY GLASSES
VEHICLE
FRAME
HOLE #3
HOLE #6
HOLE #5
11