Cequent REESE Towpower 88001 Guia De Inicio Rapido página 25

VEHICLE FRAME
BUMPER
BRACKET
USE THIS HOLE
FOR CENTER
SECTION ASSEMBLY
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
1998-04 CHEVROLET S-10/GMC S-15 (SHORT BED 4 X 4 ONLY) 2001-04 CHEVROLET S-10/GMC S-15 CREW CAB
1998-2000 ISUZU HOMBRE (SHORT BED 4 X 4 ONLY)
1. Disconnect ground wire from bottom surface of passenger's side frame.
2. Raise side brackets into position. Place the mounting tab of brackets on top of frame as shown. Line up
hole 2 in bracket with large hole near end of frame.
3. Install 1/2" x 2" carriage bolt with 1/4" bolt plate down through hole 2 in side bracket and large hole
in end of frame. Place 1/4" x 1-1/2" x 3" block on carriage bolt and loosely install 1/2" flat washer,
lock washer and hex nut.
4. Measure 3-3/4" forward from the center of carriage bolt and drill a 1/2" hole in the bottom of frame.
NOTE: The drilled hole should line up with hole 3 of side bracket.
5. Install 1/2" x 2" carriage bolt with 1/4" bolt plate down through hole 3 in side bracket and drilled hole
in bottom of frame. Loosely install 1/2" flat washer, lock washer and hex nut, both sides.
6. Install center section per SIDE BRACKET LOCATION 3. (See page 3.)
7. Reattach ground wire to one of the unused holes in side bracket or plate.
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE
INSTALLATION S
1/2 x 2" CARRIAGE BOLT
1/4" BOLT PLATE
HOLE 3
HOLE 2
REMOVE GROUND WIRE
1/4" X 1-1/2" X 3"
BOLT PLATE
TOOLS REQUIRED
3/4" SOCKET
1/2" DRILL
TORQUE WRENCH
SAFETY GLASSES
DRILLED HOLE
1/2" FLAT WASHER
1/2" LOCK WASHER
1/2" HEX NUT
25