Section 1. Important Safety Instructions; Safety Instructions - Zodiac Jandy VS FloPro VS-FHP Serie Manual De Instalación Y Operación

Page 4
ENGLISH
Section 1. IMPORTANT SAFETY INSTRUCTIONS
READ AND FOLLOw ALL INSTRUCTIONS
1.1

Safety Instructions

All electrical work must be performed by a licensed electrician and conform to all national, state, and local codes.
When installing and using this electrical equipment, basic safety precautions should always be followed, including the
following:
RISK OF SUCTION ENTRAPMENT HAZARD, wHICH, IF NOT AVOIDED, CAN RESULT IN SERIOUS
INJURY OR DEATH. Do not block pump suction, as this can cause severe injury or death. Do not
use this pump for wading pools, shallow pools, or spas containing bottom drains, unless the pump is
connected to at least two (2) functioning suction outlets. Drain covers must be certified to the latest
published edition of ANSI/ASME A112.19.8.
To reduce the risk of injury, do not permit children to use this product.
To reduce the risk of property damage or injury, do not attempt to change the backwash (multiport, slide,
or full flow) valve position with the pump running.
Zodiac Pumps are powered by a high-voltage electric motor and must be installed by a licensed or
®
certified electrician or a qualified swimming pool service technician.
Due to the potential risk of fire, electric shock, or injuries to persons, Zodiac
in accordance with the National Electrical Code (NEC), all local electrical and safety codes, and the
Occupational Safety and Health Act (OSHA). Copies of the NEC may be ordered from the National Fire
Protection Association, 470 Atlantic Ave., Boston, MA 02210, or from your local government inspection
agency.
RISK OF ELECTRIC SHOCK, FIRE, PERSONAL INJURY, OR DEATH. Connect only to a branch
circuit that is protected by a ground-fault circuit-interrupter (GFCI). Contact a qualified electrician if you
cannot verify that the circuit is protected by a GFCI. Make sure such a GFCI should be provided by
the installer and should be tested on a routine basis. To test the GFCI, push the test button. The GFCI
should interrupt power. Push the reset button. Power should be restored. If the GFCI fails to operate
in this manner, the GFCI is defective. If the GFCI interrupts power to the pump without the test button
being pushed, a ground current is flowing, indicating the possibility of electrical shock. Do not use the
device. Disconnect the device and have the problem corrected by a qualified service representative
before using.
Incorrectly installed equipment may fail, causing severe injury or property damage.
• Do not connect system to an unregulated city water system or other external source of pressurized
water producing pressures greater than 35 PSI.
• Trapped air in the system can cause the filter lid to be blown off, which can result in death, serious
personal injury, or property damage. Be sure all air is out of the system before operating.
Jandy ® FloPro™ Variable-Speed Pump Series VS-FHP
wARNING
wARNING
wARNING
wARNING
wARNING
wARNING
wARNING
wARNING
|
Installation and Operation Manual
Pumps must be installed