Battipav FORAGRES 070 Manual De Instrucciones página 24

GB
4) Fill the basin until, and not beyond, the level
5
marked by the label located on the machine
side.
5) Connect the FORAGRES machine to the low
voltage power supplier.
In order not to block the cutter, it is advisable to
always keep the thread perfectly greased with
waterproof grease.
CHECKING BEFORE USE
CAUTION
THE FORAGRES MACHINE HAS BEEN DESIGNED
FOR WORKING WITH WATER.
5 • Before and during drilling operations, make
sure that the water level is the same as the
one indicated in the relevant label located on
the machine side.
• In order to obtain the best performance under
maximum safety conditions, always keep the
machine clean.
• Check the machine cable regularly.
• During operation, keep watch on the worn
parts, and make sure that the loose parts are
secured and that the accessories are correctly
installed.
CAUTION
6 TILE STOPPER - Art. 072 (optional)
Using the tile stopper locking lever, the drilling
distance can be set out.
CONNECTING TO POWER SUPPLY
CAUTION
The machine is to be connected to the power supply
by a residual current circuit breaker (RCCB) with the
following characteristics:
RCCB
N.B. To ensure correct functioning, periodically
check the efficiency of RCCBs by pressing the
push-button on the front of the device.
24
In 16 A Id 30 mA
• The FORAGRES machine works at safety extra-
low voltage (SELV) thanks to its own power
supplier equipped with a class II isolation
transformer.
The machine power supplier can be connected to
a 230V ~ 50-60Hz supply mains.
• Before connecting the machine to the power
socket, check that the power supply voltage
corresponds to that shown on the plate on the
machine.
DRILLING
CAUTION
7 BEFORE STARTING
OPERATIONS, THE OPERATOR MUST MAKE
SURE THAT AT LEAST 150 cm ARE LEFT FREE
AROUND THE MACHINE (Pos. 2 Picture 7).
IN ORDER TO WORK IN SAFETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN NEAR
THE MACHINE
OPERATIONS.
THE OPERATOR STANDS IN THE WORKING
POSITION (Pos. 1 Picture 7) DURING THE
DIFFERENT MACHINE OPERATION PHASES.
Select, by means of the commutator located in the
power supplier, the right cutting speed, according to
the following indications:
I° speed for cutter from
II° speed for cutter from
III° speed for cutter from
CAUTION
THE NUMBER OF REVOLUTIONS MUST ALWAYS
BE PROPORTIONAL TO THE DIAMOND CUTTER
DIAMETER, SO AS NOT TO DAMAGE IT.
8 The machine is started with the switch located in
the handle.
Battipav srl
THE DRILLING
DURING THE CUTTING
150 mm a 60 mm
59 mm a 30 mm
29 mm a 8 mm