About This Guide; Package Contents; Switch Installation; Rack Installation - D-Link DGS-1008MP Guia De Instalacion

About This Guide

The D-Link DGS-1008MP Power over Ethernet
Gigabit Desktop Switch is a stand-alone plug-and-
play device. This Quick Installation Guide gives
step-by-step instructions for setting up the device.
The model you have purchased may appear slightly
different from the images shown in this guide. For
more detailed information about the switch, installation
process, making network connections, and technical
specifications, please refer to the User Manual or visit
http://www.dlink.com

Package Contents

These are the items included with your purchase:
• 8-Port DGS-1008MP Gigabit Ethernet PoE
Switch
• Quick Installation Guide
• AC power cord
• Four rubber feet
• Screws and two mounting brackets
If any of the above items are missing, please contact
your reseller.
Installation Guidelines
As with any electronic device, you should place the
equipment where it will not be subjected to extreme
temperatures or humidity, vibration, dust, direct
sunlight, or electromagnetic interference. Specifically,
the site you select should meet the following
requirements:
A. Install the DGS-1008MP in a cool and dry place.
The ambient temperature should be between
0 and 40 degrees Celsius (32 to 104 degrees
Fahrenheit). The relative humidity should be less
than 90 percent, non-condensing.
B. Install the switch in a site free from a strong
electromagnetic source. Surrounding electrical
devices should not exceed the electromagnetic
field (RFC) standards for IEC 801-3, Level 2 (3
V/M) field strength.
C. Make sure that the equipment receives adequate
ventilation. Leave at least 10 cm of space at
the left and right-hand side of the switch for
ventilation. Do not block the ventilation holes on
either side of the switch.
D. The power outlet should be within 1.2 meters of
the device.
2 2
E. Do not stack any device on top of the switch.

Switch Installation

The DGS-1008MP can easily be mounted in an EIA
standard size 19-inch rack which can be placed in
a wiring closet with other equipment or placed on a
desktop or shelf.
Desktop or Shelf Installation
When installing the switch on a desktop or shelf, use
the rubber feet provided. Position and apply the rubber
feet to the bottom corners of the DGS-1008MP switch.
Figure 1 - Attach rubber feet

Rack Installation

To install in a rack, attach the mounting brackets
to the switch's side panels (one on each side) and
secure them with the screws provided. Then, use the
hardware provided with the equipment rack to mount
the switch in the rack.
Figure 2 - Attach mounting brackets
Figure 3 - Mount switch in rack