Available Options - JB Systems FL30-WW-3528-5M Manual Del Operador

ENGLISH
D.
These 1-color LED strips can be controlled in 2 different ways:
a. NON DIMMABLE OPERATION:
Use the supplied low voltage power cable to
connect the LED strip to a stabilized 24Vdc
power supply which can deliver enough
power to drive the LED strip. In the
beginning of this chapter you can learn how
to calculate which power supply you need.
Our "FL-PSU60W-24VDC" power supply
(order code 5361) is an excellent choice for
applications
2500mA).
b. DIMMABLE OPERATION VIA DMX:
If the 1color LED strips should be dimmed or controlled by an
external (DMX) controller, than this is the best solution. Using
our standard LED MANAGER-series you can dim 3different 1-
color strips separately by using the R,G and B outputs.
1. Cut off the round DC-connector on one side of the supplied
low voltage power cable(s).
2. Strip the 2 wires of the low voltage power cable(s) and
connect the red wire(s) to the +24V output of the LED
Manager. The other wire can be connected to one of the
other outputs: R, G or B:
 When you connect the wire to the R output (STRIP1),
you will be able to control the LED strip by controlling the
color "red" on the LED Manager.
 When you connect the wire to the G output (STRIP2),
you will be able to control the LED strip by controlling the
color "green" on the LED Manager.
 When you connect the wire to the B output (STRIP3),
you will be able to control the LED strip by controlling the
color "blue" on the LED Manager.
Important: you can control 3 different single color LED strips
with only one LED Manager. However don't forget to calculate
the exact power consumption!  Very important while
choosing the right LED Manager to do the job!
c. OTHER WAYS TO CONTROL:
Often we bring new controllers to the market, please check our
website for our latest products.
Important notice: The LED strips are IP65 waterproof but the connection system is not! If you want to use the LED strips
outside, add extra protection to the connections: put a thermal gain over the connectors and/or use translucent silicon
(used for bathrooms) on the connectors to protect them from water. If you use soldering for the cables and extensions, you
should use the same protections.
Hint: You can install the LED-strips also behind opal plastic panels to create color changing walls and ceilings or in a bar
you can install the strips under a translucent shelf to light up bottles and drinking glasses from the bottom.

AVAILABLE OPTIONS:

You want to be even more creative with LED STRIPS? Check out these:
 T-CONN: A T-shaped connector so you can easily make a center tap on the LED strip line.
 L-CONN: An L-shaped connector to change the direction of the LED strip by 90°.
JB SYSTEMS
®
up to 60Watts (2.5A or
3/20 FL30/FL60/FL120-WW-3528/5050-5M
USER MANUAL