Thermador Pro Harmony Professional Serie Manual De Instalación página 4

Tools Needed
• T-20 Torx head screwdriver or drill
• Protective Work Gloves
Attach the backguard before sliding the appliance into the
final installed position.
1. Remove the three (3) or four (4) T-20 Torx stainless
screws in the front face of the included Island Trim.
2. Remove the three (3) or four (4) T-20 Torx drill point
screws securing the trim to the side panels, and the
three (3) or four (4) T-20 Torx drill point screws
securing the piece to the back panel. Lift up to fully
remove.
Page. 3
3. Align the back panel of the new accessory with the
flanges on the range side panel's right and left rear
corners. The backguard is inserted inside the guide
channels on the back of the range.
4. Make sure the backguard's front face is outside the
flange on the front side of the range.
5. Re-install screws removed in Steps 1 and 2.