PALSON Diábolo Plus Modo De Empleo página 31

GB
installing and dismantling the side brush:
Installation:
1. Loosen the screw in the main shaft
of the side brush before changing it.
Dismantling:
2. Push the side brush against the
main shaft and then tighten the
screw. (See figure).
Cleaning the side and floor
brushes:
1. For optimum cleaning, frequently
remove built-up hair and dust
from the rubber and floor rollers.
Clean any dust build-up on the air
intake. Remove waste paper or
dust directly using the dust brush.
Carefully rotate the brush and
cut out any built-up hair, threads
or other entangled objects using
scissors or pull them out by hand.
2. The main brush and rubber roller
can be cleaned following the
installation and dismantling section.
installing/dismantling and cleaning the left/right wheel
1. Loosen the screw in the left/
right wheel using a screwdriver.
(See figure 1).
2. Remove the left/right wheel
and clean it with the brush
(see figure 2).
Do not clean with water!
3. Fit the left/right wheel in its original
position and tighten the screws
during installation.
figure 1
figure 2
31