Module Installation - Wolf Steamer Module Guia De Instalacion

SP ECI F IC AT I O N S
Steamer Module
INSTA L L AT IO N
330 457
mm mm
178
mm
200
mm
SIDE VIEW
NOTE: Shaded area above countertop indicates minimum clearance to combustible surfaces,
combustible materials cannot be located within this area.
Sub-Zero, Sub-Zero & Design, Sub-Zero & Snowflake Design, Dual Refrigeration, The Living Kitchen, Great American Kitchens The Fine Art of Kitchen Design, Wolf, Wolf & Design, Wolf Gourmet, W & Design, red colored knobs, Cove, and Cove & Design, are registered trademarks and service marks of Sub-Zero Group, Inc. and its subsidiaries.
All other trademarks are property of their respective owners in the United States and other countries.
64 mm
min
356 495
mm mm
64 mm
min
COUNTERTOP CUT-OUT
762
mm
152
314 mm
mm
DRAIN
OUTLET
E
FRONT VIEW
INSTA L L AT IO N

Module Installation

Remove the module and components from the shipping
package and recycle packing materials.
Lower module into the opening. Center module with
1
the front parallel to the edge of the countertop. Using
a pencil, outline the rear edge of the module on the
countertop.
Remove module.
2
Apply the foam strip to the underside of the module
3
frame. Refer to the illustration below. Do not seal module
to the countertop.
Insert module into the opening, aligning rear edge with
4
the pencil line. Verify module is aligned with the edge of
the countertop.
To attach brackets to the sides of the module, insert
5
clips into the side punchouts and press down. Install
clamping screws into the brackets and tighten until
screws contact the underside of the countertop. Do not
overtighten. Refer to the illustration below.
FOAM STRIP
COUNTERTOP
CLIP
CLAMPING
BRACKET SCREW
Module installation.
TRO UB L E SH OO TIN G
Troubleshooting
IMPORTANT NOTE: If the module does not operate properly,
follow these troubleshooting steps:
• Verify electrical power is supplied to the module.
• If the module does not operate properly, contact Wolf
factory certified service. Do not attempt to repair the
module. Wolf is not responsible for service required to
correct a faulty installation.
wolfappliance.com
|
3