Installation Instructions - Envirolite EVT1012 Manual De Instrucciones

PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
2 ea Bracket Mounting
Screws (#5)
3 ea Wire
Nuts (#14)

INSTALLATION INSTRUCTIONS:

1. Remove the Canopy Mounting Screws (#6) from the Mounting Bracket (#4). Keep the Canopy Mounting
Screws (#6). (Fig. 2)
2. Rotate the Swivel Bar (#9) of the Mounting Bracket (#4) so that it is perpendicular to the Straight Bar
(#7). (Fig. 3)
3. Pull the power supply wires out from the Outlet Box (#3), and mount the Mounting Bracket (#4) to the
Outlet Box (#3), using the Bracket Mounting Screws (#5). (Fig. 4)
4. Turn the Swivel Bar (#9) to the desired position, keeping in mind that it will determine the final
orientation of the Fixture itself. Tighten both Center Screws (#17). (Fig. 4)
5. Attach the Black Supply Wire (#14) to the Black Fixture Wire (#10) and the White Supply Wire (#15) to
the White Fixture Wire (#11) using Wire Nuts (#13). Connect the Fixture Ground Wire (#12) and the
Supply Ground Wire (#16) together using a Wire Nut (#13). Wrap all wire connections with electrical
tape for a more secure connection. (Fig. 5) Note: If you have electrical questions, consult your local
electrical code for approved grounding methods.
6. Carefully tuck all Wires and Wire Nuts (#13) into the Outlet Box. Place the Canopy (#8) of the Fixture
over the Outlet Box (#3), flush against the ceiling surface, making sure the Canopy Mounting Holes align
with the Mounting Holes of the Swivel Bar (#9). Thread the Canopy Mounting Screws into the Canopy
Mounting Holes to secure the Canopy (#8) onto the Swivel Bar and flush against the ceiling. (Fig. 6)
7. Proceed back to the Assembly Instructions.
8. Installation is complete. Turn on power at the circuit breaker or fuse box. Turn the light switch on to
activate the fixture.
1 ea Mounting
Bracket (#4)
1 ea Fixture (#1)
Page 3