Installation & Assembly - Envirolite EVTR22BL20PD2 Manual De Instrucciones

INSTALLATION & ASSEMBLY:
1. Turn off the power at the circuit breaker box.
2. Remove the fixture from the packaging.
3. Rest the luminaire on the T-Bar of the ceiling
suspension system in the desired location (Fig. 1).
4. From above the ceiling, secure the Troffer to T-Bar
by bending built in T-bar clips (#1) on all four
corners of the fixture (Fig. 2).
5. If local code requires, tie a wire to at least two of
the four T-bar clips (#1) located near each corner
of the Troffer to a structural member of the ceiling
(Fig. 2).
6. Remove the access plate located on end of fixture
(#2) and locate the black fixture wire and the
white fixture wire (Fig. 3).
7. Remove the access plate located on end of fixture
(#3) and locate the purple fixture wire and the
grey fixture wire (Fig. 3).
8. Thread the power supply wires through the
knockout hole in the access plate (#2) (Fig. 3).
9. Connect the black supply wire and the white
supply wire to the quick connector. Connect the
supply ground wire to the fixture ground screw.
10A. Cap off the purple and grey fixture wires
individually with a wire nut if the fixture will not be
connected to a dimmer; otherwise go to 10B (Fig.
4).
10B. Thread the power supply wires through the
knockout hole in the access plate (#3) (Fig. 3).
Connect the purple and grey fixture wires to
corresponding wires of the wall 0-10V dimmer
(Fig. 5).
11. Restore power at the circuit breaker box
Page 4
Fig. 1
Fig. 2
Fig. 3
PURPLE FIXTURE WIRE
GREY FIXTURE WIRE
.
NO DIMMING
PURPLE FIXTURE WIRE
GREY FIXTURE WIRE
Fig. 4
DIMMING CONNECTIONS
PURPLE DIMMER WIRE
GREY DIMMER WIRE
Fig. 5