EarthWise TC70025 Manual Del Operador página 6

UPPER AND LOWER HANDLE SECTIONS (Fig. 3A)
Slide the lower handle section into the upper handle
section. Line up the holes on each tube, and make sure
the cable is clear of the mounting holes. Secure the two
sections together with the M6x45 carriage bolt and wing
nut.
LOWER HANDLE WITH TILLING HEAD (Fig. 3B)
Align the notch on the lower handle with the rib on the
tilling head, and push the lower handle into the tilling
head. Align the side cover with the holes on the lower
handle shaft and push the cover into place. Secure with
the two ST3.9x19 Philips head self-tapping screws.
3
ASSEMBLY
AUXILIARY HANDLE (Fig. 3C)
Position the auxiliary handle so that the holes are in
alignment with the holes in the handle support bracket.
Insert the M6X50 hex head bolt into the hex shaped bolt
hole of the bracket. Secure by tightening the wing nut
onto the bolt.
Loosen the wing nut and adjust the angle and height of
the handle to a safe and comfortable position. Secure
into place by tightening the wing nut onto the bolt.
6