Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word "DANGER" or "WARNING."
These words mean:
DANGER
WARNING
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed:
¹⁄₂" Wrench
Parts Supplied:
Mounting brackets (3)
Hex-nuts (6)
Bracket Use Requirements
Intended for use with Gladiator
GearLocker cabinets only.
NOTE: These brackets are not designed to be installed on
cabinet models: GATGB000LG0 and GATGBL00LG0.
Intended to be used for mounting on Gladiator GearWall
or GearTrack™ channels.
Brackets will support a cabinet with a maximum weight limit of
300 lbs (136 kg).
Unpack Brackets
1. Verify contents. See "Parts Supplied."
2. Dispose of/recycle all packaging materials.
2
MOUNTING BRACKET SAFETY
Your safety and the safety of others are very important.
INSTALLATION INSTRUCTIONS
¹⁄₄" x ¹⁄₂" Carriage bolts (6)
Washers (6)
®
Welded-Steel Tall GearBox &
You can be killed or seriously injured if you don't immediately
follow instructions.
You can be killed or seriously injured if you don't follow
instructions.
Attach Mounting Brackets
IMPORTANT: There are three groups of four slots in the back panel
of the tall cabinet. The mounting brackets must be attached to the
top pair of slots in each group.
Attach Top Mounting Bracket
1. With the rims of a mounting bracket pointing down, align the
holes in the bracket with the top pair of slots in the back panel.
2. Working from the back, insert a carriage bolt through the bracket
and back panel as shown.
A
®
panels
3. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut.
4. Slide the bracket to the very top of the slot and fully tighten the
nuts.
A. Carriage bolts
B. Bracket rim
B
Publicidad
Tabla de contenido
