Mount The Cabinet To Gearwall Panels Or Geartrack™ Channels; Important - Gladiator GABK301PRS Manual De Instrucciones

Attach the Middle and Bottom Mounting Brackets
1. With the rims of a mounting bracket pointing down, align the
holes in the bracket with the top pair of slots in the back panel.
2. Working from the back, insert a carriage bolt through the bracket
and back panel.
3. Working from the cabinet interior, fasten each bolt with a washer
and a hex nut.
4. Only hand tighten the nuts attaching the middle and bottom
brackets. These brackets will need to be adjusted to mount the
cabinet on the wall.
IMPORTANT: Fully tighten the nuts on the middle and bottom
brackets after mounting the cabinet to the wall, See "Mount the
Cabinet to GearWall ® Panels or GearTrack™ Channels."
Mount the Cabinet to GearWall
GearTrack™ Channels

IMPORTANT:

Be sure the GearWall ® panels or GearTrack™ channels are
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
If GearTrack™ channels will be used to support the Gladiator
Tall GearBox cabinet, they must be installed 18" (45.72 cm)
apart.
18" (46 cm)
NOTE: The two nuts on the center and bottom mounting brackets
must be loose enough to allow the brackets to move in the slots on
the cabinet.
1. Close the cabinet doors.
2. Determine cabinet mounting location on GearWall
GearTrack™ channel.
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
3. Using two or more people, engage the top bracket into the slots
by lifting up, pushing toward the wall and lowering the bracket
rims into the slots as shown.
4. Make sure the top bracket is fully engaged in the slots as shown.
A
B
5. Open the cabinet doors.
6. From inside the cabinet, grasp the bolts in the middle bracket
and adjust the bracket until it aligns with the slot in the GearWall
panels or GearTrack™ channels.
7. Push the cabinet toward the wall and lower the center mounting
bracket into the slots.
8. Make sure the center bracket is fully engaged in the slot as
shown.
®
Panels or
9. Repeat for the bottom bracket.
10. Using a ¹⁄₂" wrench, fully tighten the nuts attaching the center and
bottom brackets.
®
WARNING
Excessive Weight Hazard
C
A. Bracket rim C. Bracket fully
engaged
B. Slot
® panels or
®
3