Black+Decker BXCO1200E Instrucciones Originales página 8

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 28
ENGLISH
(Original instructions)
ANOMALIES AND REPAIR
Š Take the appliance to an authorised technical support
service if problems arise. Do not try to dismantle or
repair without assistance, as this may be dangerous.
Š If the connection to the mains has been damaged, it
must be replaced and you should proceed as you would
in the case of damage.
Š If you detect any anomalies, refer to the following table:
Anomaly
Possible cause
Water flows out of the
The filterholder is not fitted correctly.
side of the holder
The Edge of the sieve is covered with
coffee.
The brewing group is dirty.
No coffee comes out
There is no water
The water tank is not properly placed.
The filter holes are clogged, the coffee is
ground too fine or has been pressed too
much
The coffee comes out
The coffee grinding is too fine or too
slowly or drop by drop
pressed
The coffee comes
The used Coffee is out of date
without cream
The Coffee has not been pressed enough.
the Ground coffee is too coarse.
The coffee comes out
The ground coffee is too coarse.
too fast
There is not enough coffee in the sieve.
The Coffee has not been pressed enough
No steam escapes from
The Tube is clogged
the evaporator tube
For EU product versions and/or in the case
that it is requested in your country:
Ecology and recyclability of the product
Š The materials of which the packaging of this appliance
consists are included in a collection, classification and
recycling system. Should you wish to dispose of them,
use the appropriate public recycling bins for each type
of material.
Š The product does not contain concentrations of substan-
ces that could be considered harmful to the environment.
8
Solutions
See Section «filling coffee»
Clean the sieve around the edge and clean
the brewing of coffee group
Clean With a damp cloth.
Fill the water tank
Make sure the tank is properly seated,
pressing on the top
Empty the filter basket and clean with water.
Clean the brewing unit with a damp cloth. Fill
the sieve again and press the coffee slightly
Make sure grinding is OK and it's not too
pressed.
Use Fresh coffee and once opened store in
an airtight container.
Press slightly the coffee.
Grind finer the coffee
Grind coffee finer
Ensure that it's the right amount of coffee in
the sieve.
Press slightly the coffee
Clean the steam tube with a damp cloth to
remove any traces of milk have dried and
unblock holes using a needle. Press the
corresponding switch and remove steam
until it goes out continuously
This symbol means that in case you wish to
dispose of the product once its working life has
ended, take it to an authorised waste agent for
the selective collection of waste electrical and
electronic equipment (WEEE)

Publicidad

Tabla de contenido
loading

Tabla de contenido