Marmitek VIDEOCONTROL3 Modo De Empleo página 6

• Position the IR LED within range of the remote control, e.g. on the top of the TV.
• Plug the power adapter into the wall socket.
Tip 1
There are two types of antenna plugs in Europe: the IEC plug and the F plug. This last
one causes the least loss of signal and is used in superior installations. Your Marmitek
VideoControl3 also uses an F plug. With the adapters included you can also connect
IEC plugs.
Installation of the transmitter
• Connect the 'IN' side of the VideoControl3 transmitter (with the character
device and with the IR LEDs) to the COAX cable near the satellite receiver or video
recorder in the room the equipment you want to control is situated.
• Connect the 'TO TV' plug to the antenna IN of the TV or satellite receiver.
• Use the coax extension plug included if necessary.
• Stick the LEDs on the IR windows of the equipment. This should be done very
carefully and precisely. Test whether the LEDs are in the right
place first (with another person holding them) before you stick them down.
• Plug the power adapter into the wall socket.
ATTENTION: if you connect less than 3 devices, do not remove the other LEDs from
the cable.
6
T
on the
© MARMITEK