Environmental Protection; Technical Data - Metabo SBE 18 LTX Manual Original

en ENGLISH
11. Repairs
Repairs to electrical tools must ONLY be carried out
by qualified electricians!
Contact your local Metabo representative if you
have Metabo power tools requiring repairs. See
www.metabo.com for addresses.
You can download a list of spare parts from
www.metabo.com.

12. Environmental Protection

Do not allow battery packs to come into contact with
water!
Protect the environment and do not dispose
of power tools and battery packs with house-
hold waste. Observe national regulations on
separated collection and recycling of disused
machines, packaging and accessories.
Discharge the battery pack in the power tool before
disposal. Prevent the contacts from short-circuiting
(e.g. by protecting them with adhesive tape).
f

13. Technical Data

Explanatory notes on the specifications on page 3.
Subject to change in accordance with technical
progress.
U = Voltage of battery pack
n = No-load speed
1
ø max = Maximum drill diameter
s max = Maximum impact rate
b = Chuck clamping range
G = Drill spindle thread
H = Drill spindle with hexagon socket
m = Weight with smallest battery pack
D = Collar diameter
Measured values determined in conformity with
EN 60745.
Direct current
The technical specifications quoted are subject to
tolerances (in compliance with the relevant valid
standards).
Emission values
These values make it possible to assess the
emissions from the power tool and to compare
different power tools. The actual load may be higher
or lower depending on the operating conditions, the
condition of the power tool or the accessories.
Please allow for breaks and periods when the load
is lower for assessment purposes. Arrange
protective measures for the user, such as
organisational measures based on the adjusted
estimates.
Vibration total value (vector sum of three directions)
determined in accordance with EN 60745:
a = Vibration emission value (impact drilling
h, ID
into concrete)
a = Vibration emission value
h, D
(Drilling in metal)
K = Uncertainty (vibration)
h, ID/D
12
Typical A-effective perceived sound levels:
L = Sound-pressure level
pA
L = Acoustic power level
WA
K , K = Uncertainty
pA WA
The noise level can exceed 80 dB(A) during
operation.
Wear ear protectors!