Maintaining The Air Filter; Adjusting The Idle Speed - Remington RM2520 Manual Del Operador

2 tiempos
Ocultar thumbs Ver también para RM2520:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

MAINTAINING THE AIR FILTER

WARNING:
To avoid serious personal injury, always stop
the engine and allow it to cool before cleaning or maintaining
the unit.
Failure to maintain the air filter can result in poor performance or can
cause permanent damage to the engine. Engine failure due to
improper air filter maintenance is not covered by the product warranty.
Cleaning the Air Filter
1. Open the air filter cover: press in the lock tab and swing the air
filter cover to the right (Fig. 20).
2. Remove the air filter from inside the air filter cover (Fig. 20).
3. Wash the air filter in detergent and water. Rinse the air filter
thoroughly and allow it to dry.
4. Lightly coat the air filter with clean SAE 30 oil.
5. Squeeze the air filter to spread and remove excess oil.
6. Reinstall the air filter inside the air filter cover (Fig. 20).
NOTE: Operating the unit without the air filter and air filter cover will
VOID the warranty.
7. Close the air filter cover: swing the air filter cover to the left and
press it closed until the lock tab snaps into place (Fig. 20).

ADJUSTING THE IDLE SPEED

WARNING:
The cutting head may spin during idle speed
adjustments. Wear protective clothing and observe all
safety instructions to prevent serious personal injury.
NOTE: Careless adjustments can seriously damage the unit. A qualified
service dealer should make carburetor adjustments.
If, after checking the fuel and cleaning the air filter, the engine still
will not idle, adjust the idle speed screw as follows:
1. Start the engine. Refer to Starting and Stopping.
2. Release the throttle control and let the engine idle. If the engine
stops, use a small Phillips screwdriver to turn the idle speed screw
clockwise, 1/8 of a turn at a time (as needed) until the engine idles
smoothly (Fig. 21).
3. If the engine is idling too quickly, turn the idle speed screw
counterclockwise, 1/8 of a turn at a time (as needed) to reduce the
idle speed (Fig. 21).
Checking the fuel, cleaning the air filter, and adjusting the idle speed
should solve most engine problems. If not, and any of the following
conditions are true, take the unit to a qualified service dealer:
the engine will not idle
the engine hesitates or stalls on acceleration
there is a loss of engine power
Lock Tab
13
Air Filter
Air Filter Cover
Fig. 20
Idle Speed Screw
Fig. 21

Publicidad

Tabla de contenido
loading

Tabla de contenido