Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATING INSTRUCTIONS
Read all the sections of this booklet and follow all the instructions carefully.
Using for the First Time
WARNING:
Never plug in the control
panel when it is not installed in the fryer
body with heating element in the oil
container. Do not immerse the control
panel, cord or plug in water.
WARNING:
This unit should not be
used to boil water.
Prior to First Use, Clean the Unit
Thoroughly
WARNING:
Always let the fryer cool
completely for 2 hours before taking it
apart for cleaning. Never carry or move
the deep fryer with hot oil inside. Before
cleaning, always make sure the plug is
not in the wall socket.
•
All components with the exception of
the electrical parts, can be washed in
warm soap water. Dry thoroughly
before use.
•
Use basket handles to remove the
frying basket. Always make sure the
basket handles are securely attached
to the baskets. To attach the handles
to the frying baskets, insert the metal
part of the handle inside the metal
bracket on the frying basket. (Fig. 1)
Fig. 1
•
Lift the control panel with heating
element out of its slots by pushing it up
from the bottom with one hand while
holding the body of the deep fryer with
your the other hand.
•
Remove the oil container.
•
Clean the oil container and the frying
basket with hot water, dishwashing
liquid or other non-poisonous detergent
and non-abrasive sponge.
WARNING:
Never immerse the control
panel in water or any other liquids.
WARNING:
All components must be
completely dried before filling with oil or
using. Special care must be taken to
ensure the washable oil filter in the lid is
completely dry, otherwise the filter will
not function properly and may lead to
steam being trapped within the fryer
during use.
WARNING:
Never exceed "MAX" line
when filling the basket with food.
Filling the Oil Container
WARNING:
Never plug in the deep
fryer before filling with oil to specified
level. Always make sure control panel
is securely in place in the body and the
heating element is inside the oil in the
container before plugging in.
•
Use blended vegetable oil, pure corn
oil or canola (rapeseed) oil. Do not
use olive oil, margarine, lard or
drippings.
•
The oil level must always be
maintained between the minimum
and the maximum levels marked
inside the oil container. Check the oil
level before each use. For best
results, Do NOT exceed "MAX" level
for cooking oil. (Fig. 2)
•
Never mix different oils and fats
together. Do not mix old and new
oil.
3
Using Solid Fat
WARNING:
Do not put solid shortening
in the oil container or the frying basket.
•
If using solid vegetable shortening,
melt it first in a separate pan and then
very carefully pour the melted fat into
the oil container.
•
Previously used solid vegetable
shortening which has curdled and
hardened in the oil container should be
removed from the oil container and
melted in a separate pan before
reusing.
WARNING:
If you try to melt the
solidified fat in the oil container, there is a
risk of warm melted fat suddenly
sputtering from below through the still
solid top layer of fat.
Therefore use only the following
procedure:
•
Make sure the fat is at room
temperature. If the fat is very cold,
there is a greater risk of splashing.
•
Using a fork, carefully make some
holes in the fat. Make sure the lid is
securely closed while fat is melting.
Press the "Function" Reset button
and press timer button to set the time
you require.
Installing the "Control Panel with
the Heating Element" into its Place
•
Lift up the control panel with heating
element.
•
Insert the "guide edges" on the
control panel into the "guide rails"
mounted on the metal body. (Fig. 3)
•
Slide the "guide edges" down till the
end.
Guide Rails
Fig. 2
Fig. 3
Back of Main Body
OPERATING INSTRUCTIONS
Important Notice:
safety switch ensures that the unit will
not operate unless the control panel has
been inserted into the "guide rails" on
the metal body correctly. (Fig. 4)
Control Panel
Guide
Edges
Safety Switch
Using the Electronic Deep Fryer
WARNING:
fryer before filling with oil to specified
level. Always make sure control panel is
securely in place in the body and the
heating element is inside the oil in the
container before plugging in.
IMPORTANT:
panel is fitted correctly to the main unit
otherwise the unit will not function. This
is not a defect. This product is fitted with
a safety switch to prevent the unit from
turning on accidentally.
4
The automatic
Fig. 4
Heating Element
Never plug in the deep
Ensure the control
Publicidad
Tabla de contenido
