Westinghouse 63642 Manual De Instrucciones página 26

FUNCTION AND OPERATION
GB
Turn on the power at fuse or circuit box.
Adjusting the Sensor Head:
1. After all motion sensor adjustments are completed, rotate the motion sensor (O) so the
controls are facing mounting bracket (P) and two dots (K) are in alignment. (See Fig. 2)
2. Sensitivity of Motion Sensor
• You can adjust the sensitivity of the motion sensor (O) by using the "MOTION SENSITIVITY"
selector located at the back of the sensor (See Fig. 4). Walk through the detection zone at the
farthest distance you wish to detect motion.
Note: Range set too high may increase false triggering.
• Adjust motion sensor (O) sensitivity to achieve desired performance.
• Approximate range for each setting from 3m to 12m.
Adjusting the Light Head:
1. Gently grasp the light heads and move them up or down, left or right to adjust the light
coverage area. (See Fig. 3)
2. Keep the light heads 30° below horizontal to avoid water damage and electrical shock.
Note: When power is first applied, the light will turn on. The sensor will take 30 seconds to
warm up.
1. " " MODE (daytime and nighttime operation) (See Fig. 4)
• Set the knob to "
stays on when motion is detected.
When motion is no longer detected, it remains on for the predetermined shut-off delay time
as you set (5s~3min), and then turns off automatically.
• In " " mode, can test lighting and sensitivity.
2. " " MODE (nighttime operation only) (See Fig. 4)
• Set the knob to " " position, the light turns on after expiration of the warm-up period, it
stays on when motion is detected.
When motion is no longer detected, it remains on for the predetermined shut-off delay time
as you set (5s~3min), and then turns off automatically.
• The light will turn off automatically at dawn.
3. Manual Override MODE (See Fig. 5)
• To shift to the manual override mode (O), turn the wall switch "OFF", then turn it "ON" within
3 seconds. The light will remain on all night long. To shift back to the "
the wall switch "OFF", then turn it "ON" within 3 seconds again.
• The light will turn off automatically at dawn.
CUSTOMIZATION OPTIONS
Shut-off Delay
• The shut-off delay is the length of time the light will stay at brightness after motion (M) is detected.
• You can set the shut-off delay by rotating the delay time knob arrow so it points to the desired
time setting within "TIME" range (5s~3min). To increase the shut-off delay, turn the knob
clockwise. To decrease the shut-off delay, turn the knob counterclockwise.
NOTES
1. The sensitivity of the motion sensor will increase as the environmental temperature gets
cooler. For best performance, gently clean the lens with a soft cloth every 1 or 2 months to
assure maximum sensitivity.
2. For best performance, install fixture at least 2,5m above the ground. At such a height, the
fixture will provide a detection distance of up to 12m at 25 degrees Celsius. (See Fig. 6)
3. The sensor (N) detects movement across a detection range of 180 degrees. (See Fig. 7)
4. The sensor (N) will be more sensitive to motion (M) across its detection path than motion (M)
directly towards it. (See Fig. 8)
5. To reduce possible nuisances, do not mount the fixture near a heat source like an air conditioner,
vent or furnace exhaust, or in a direction facing any reflecting object or other light source.
26
" position, the light turns on after expiration of the warm-up period, It
" or " " mode, turn
GS-26-MK04-WH21