Phocos MPPT Manual De Instrucciones página 12

With your new MPPT Maximum Power Point Tracker, you own a state-of-the-art device which was
developed according to the latest available technical standards. It comes with a number of
outstanding features, such as:
Maximum Power Point Tracking technology, which increases the efficiency of your PV system
Allows for the use of less expensive grid-connected solar panels for 12/24V stand-alone systems
Automatic 12/24 Volt detection
Temperature-Compensated, Three-Stage I-U Curve Charge Regulation
Full electronic protection (Reverse Polarity, Over-Current, Short-circuit, Over-Temperature, etc.)
High efficiency
DIN rail compatible
Negative ground
This manual gives important recommendations for installing and using the MPP Tracker. Read it
carefully and mind the safety and usage recommendations at the end of this manual.
Major Functions
The MPPT charges your battery much faster than a regular charge controller.
The MPPT protects the battery from being overcharged by the solar array. The charging
characteristics include several stages which include automatic adaptation to the ambient
temperature.
The MPPT adjusts itself automatically to 12V or 24V system voltage.
The MPPT has a number of safety and display functions.
Recommendations for Use
The MPPT warms up during normal operation.
The MPPT does not need any maintenance or service. Remove dust with a dry tissue.
It is important that the battery is fully charged frequently (at least monthly). Otherwise the
battery will be permanently damaged.
A battery can only be fully charged if not too much energy is drawn during charging. Keep
this in mind, especially if you install additional loads.
Mounting and Connecting
The MPPT is intended for indoor use only. Protect it from direct sunlight and place it in a dry
environment. Never install it in humid rooms (like bathrooms).
The MPPT measures the ambient temperature to determine the charging voltage. The MPPT
and the battery must be installed in the same room.
The MPPT warms up during operation, and should therefore be installed on a non-flammable
surface only.
10