Simu RSA Manual De Instrucciones página 6

3
Checking the motor's rotation direction
3.1- Powering on the product: the display indicates the value
3.2- Check the motor's rotation direction using the
- If the operation is reversed, power off the product, and revert the motor's wiring (terminals 7 and 9).
- Refer to the motor's installation manual to set the end stop system.
3.3- Measure the motor operating time using permanent running (e.g. 20sec. for rising), then set the parameter
( : Motor operating time from
4
Parameters
The default modes adjusted a SIMU correspond to the main part of installations and uses of roller garage doors.Nevertheless, the SA Hz control box can be
completely and easily programmed in order to obtain a personalized working according to the accessories connected and the specific working mode desired by
the user.
- To return to the menu, press the
ting time.
4.1- Configuring the operating mode: Parameter
- Certain operating modes impose connecting safety accessories (NF EN 12453). Non compliance with these rules can lead to a facility hazardous for its users.
The RSA Hz has six operating modes:
- : Automatic mode: Pressing the remote control opens and
closes automatically after timeout
remote control again or the detection of an obstacle reopens the door.
- : Closing time of the door (
Mandatory installation of safety accessories.
- : Sequential mode: Cyclic operation (up / stop / down /
stop...). Pressing during opening or closing stops without reversion.
- : 3-button mode: This mode is used to set separate controls for opening,
closing, and stopping the door.
2/4
et keys
- Press and hold the key
- Press and hold the key
to , 1 sec. increments)
1s.
- Use the and
display is fixed when pressing the keys).
or to return to value
(factory setting =
. During closing, pressing the
to , 1sec. increments)
STOP
STOP
to open the door.
to close the door.
- Use the and
required. One second after releasing the key, the screen indicates the parameter
value to change. (display blinks).
keys to change the value of the parameter. The last value is recorded automatically (the
(or any other value indicating the product's operation: see § 5) or after a one-minute wai-
)
- : Semi-automatic mode: Pressing the control triggers opening or closing.
Pressing again during opening has no effect. Pressing during closing reopens the door.
- : Sequential mode + Timeout: Similar to the sequential mode, but with
automatic closing aftert timeout
- : Closing time of the door (
- : Forced mode with the
keyboard (default mode): This mode is used to control the door using
the and
phase.
- Press and hold
- Press and hold
In this mode, the safety devices are not activated
with a value slightly above the time observed
keys to browse the menu and display the parameter
STOP
.
to , 1sec. increments)
and
keys on the RSA Hz box in the endstop adjustment
to open the door.
to close the door.
keys on the